DIY GoPro Handler Clone for UNDER $2.50!
Tools & Materials
- Window ice scraper $1 (Dollar Tree)
- 10/32 Wing Nut $1.24/2-pk (Lowe’s)
- GoPro thumb screw
- Flat Head Screwdriver
- 13/64 Drill bit & Drill
- Scissors/tin snips, similar tool
NOTE: Use caution when working with sharp tools, and always wear safety gear.
Removing the Scraper
Trimming the Center Plastic Support
With the knife, trim off any excess plastic to make the center plastic support thin enough to easily slide between your GoPro housing mounting prongs.
Optional: Trim top point of the center plastic support to allow the housing to swivel back and forth when mounted.
Drilling the Hole
Mounting the GoPro
Need some extra piece of mind that your GoPro will be safe? Then check out the next step. :-)
Tethering GoPro to Handler (Optional)
Don't forget to follow me here on Instructables and my other accounts for more DIY tutorials.